orepass

Chairs have angles and in the case of this stool the angle of the front legs is 6.5 degrees from the back legs. The design of the stool actually means that as long as you are consistent the angle could vary slightly.

I spent the morning dimensioning and cutting to size for the rails two for each chair (8 total). Generally things went smooth with a small problem.

As I finished up some of the lumber dimensioning a couple of fun things happened. The first was the movement in some of the off cuts I had set aside. Walked out of the shop for a few hours and these slits had opened up considerably. The second item is less enjoyable. Saw Stop blade struck what remained of a staple in the end of board, another blade damaged. If I had trimmed the end a few mm further up the board would have saved a lot of money.

It was necessary at this point to take a walk!